Working bear cub.
The following materials will be needed to make this toy: Two wooden slats thickness 5 mm, A piece of thin plywood or thick cardboard, pieces of thicker plywood, two shoemaker rivets or screws with nuts and pads, Wikol or carpentry glue, poster paints, PODOST or varnish colorless.
Working bear cub: a) ready toy, b) how to make the trunk, c) Connection of the lower slat to the trunk.
We will start work by making slats and trunk. The silhouette of the teddy bear is shown in the figure – and on a scale 1:1, Just redraw the drawing to plywood or cardboard and cut out. After all parts are made, We start joining the toy. First the lower thickness of the thickness 5 mm, length 20 cm and width 1 We grease cm with glue and slide into the trunk permanently (drawing – a, c). Trunk (drawing – b) has the following dimensions: height 4,5 cm, width 4 cm and thickness 1,5 cm. Distance between the holes on the slat – 2 cm. Upper slat, with the same dimensions as the lower one, is movable and must move freely in the trunk; To this end, her sharp edges and rough surface must be cleaned with sandpaper. Misia connection points with slats should be determined experimentally. After making the holes at the teddy bear connecting points with the slats, put on loose rivets or screws. Finally, we paint the trunk and teddy bear with poster paints, and the slats – Voireing or colorless varnish.