Leather bracelets.
If you get a piece of thick skin, then you can make a very nice bracelet. Cut the skin strap around 30 cm Yes, that one side of its side would be wider, The second, however, narrowing and completed semi -circular. In a distance 3 cm from a wider end to cut the skin in two places (drawing – a). Use a very sharp pocket knife or shoemaker's knife for this purpose. Insert the other end of the leather strap into the incision places (drawing – c). Front (laws) You can decorate the skin side for a bracelet for any decorative motif. This motive sketch gently on the skin, and then burn with hot wire above the flame of the gas burner.
Leather bracelets.
Attention! Keep the wire with puders or pliers, In order not to burn your hands; Place the skin on a metal pad, In order not to destroy the table. Apply the hot wire on the skin lightly and very short.
You can tan the edges of the skin over the flame of the burner – Then they will go inside slightly. You can also combine the ends of the skin intended for a bracelet with a thin thong, crossed out through the holes stamped with a pierced at both ends of the skin. You can finish the ends of the straps with beads or tied in the node (drawing – d).
You can also make a bracelet from a skin strap a little longer than the hand of the hand. With the entire length, knock off the holes, through which you delay a thin thong (drawing – b). You can finish by binding the slit in the way given in the figure – d.